The light warns of front passenger airbag status. If
the front passenger airbag has been deactivated,
the light comes on and stays on as long as the front
passenger airbag switch remains in the OFF posi-
tion.
Electronic Stability Programme
(ESP) warning light
When the ignition switch is in the “ON” position, the
Electronic Stability Programme (ESP) warning light
illuminates and then turns off.
The warning light blinks when the ESP system is
operating.
When the warning light blinks while driving, the driv-
ing condition is slippery and the vehicle’s traction
limit is about to be exceeded.
If the warning light illuminates when the ignition
switch is placed in the “ON” position, it may indicate
that the ESP system is not functioning properly and
may need servicing. Have the system checked, and
if necessary repaired, by a NISSAN dealer or quali-
fied workshop promptly.
If a malfunction occurs the ESP function is turned
off, but the vehicle is still driveable. (See “Electronic
Stability Programme (ESP) system (where fitted)” in
the “5. Starting and driving” section.)
INDICATOR LIGHTS
Water in fuel filter warning light
(Diesel engine)
If the warning light remains on or flashes irregularly
while the engine is running, there may be water in
the fuel filter. Should this happen, try to drain the
water from the fuel filter, see “Fuel filter (Diesel en-
gine models)” in the “8. Maintenance and
do-it-yourself” section or have the system inspected
by a NISSAN dealer or qualified workshop as soon
as possible.
CAUTION
Failure to drain the water from the fuel filter can
cause serious damage to the engine. Contact a
NISSAN dealer or qualified workshop as soon as
possible.
ECO mode system indicator
light
The ECO mode system indicator light illuminates
when the ECO mode system is turned on.
(See “ECO mode system (where fitted)” in the
“5. Starting and driving” section.)
Engine start operation indicator
light
This light appears when the shift lever is in the P
(Park) position. This light means that the engine will
start by pushing the ignition switch with the brake
pedal depressed. You can start the engine directly
in any position.
High beam indicator light
The high beam indicator light illuminates when the
headlight high beam is “ON”. The indicator turns off
when the low beam is selected. (See “Headlight
and turn signal switch” earlier in this section.)
Stop/Start System indicator
light
The Stop/Start System indicator light illuminates in
the meter when the Stop/Start System has auto-
matically turned off the engine.
The Stop/Start System indicator light with remain
illuminated until either:
The engine is automatically turned back on by the
Stop/Start System, or:
The engine automatic restart is prevented by open-
ing the engine bonnet, removing the drivers seat
belt (MT models) or opening the drivers door (MT
models).
Low temperature indicator light
(green) (where fitted)
The low temperature indicator light illuminates when
the engine coolant temperature is low.
When the ignition switch is in the “ON” position,
after the high temperature warning light (red) illumi-
nates for 1 second, the low temperature indicator
light illuminates and then turns off. After this indica-
tors that the engine coolant has warmed up.
2-16 Instruments and controls
To Next Page
Loading...