12 HOW DO I TRANSFER MY SERVICE AGREEMENT?
This Agreement is for the benefit of the Purchaser and applies only to the vehicle listed
in your Agreement. However, this Agreement may be transferred to subsequent owners
of the covered vehicle under the following conditions:
1. The vehicle’s service records are current and indicate that the vehicle was
maintained in accordance with Nissan’s recommendations. In the event service
records are not available, NESNA may require the vehicle to be inspected and
serviced at an approved repair facility at the owner’s expense to ensure the vehicle
has been properly maintained. If the inspection and service disclose abnormal
vehicle conditions, the transfer request may be rejected. This determination shall
be within the sole discretion of NESNA.
2. The transfer request is made within thirty (30) days of change in ownership.
3. The transfer information and the appropriate signatures are provided in the Transfer
Certificate section.
4. A transfer fee of $40, payable to NESNA is included with the transfer request.
Payment may be by check or money order.
A new Agreement will be mailed to the subsequent owner after NESNA’s receipt and
successful processing of all requested material.
RFDD02728926 RF0211FLINC — 7/1/2011 RF0211FLINC — 7/1/2011 RFDD02728926
4 WHAT DOES MY SERVICE AGREEMENT COVER?
This Agreement covers any repairs needed due to MECHANICAL BREAKDOWN, as
defined above, for Nissan components in the following categories:
ENGINE:
Cylinder block, head(s) and all internal parts, timing gears, tensioner(s), timing chain
or belt and cover(s), harmonic balancer (crankshaft pulley), manifolds and
collector(s), oil pump, valve cover(s), oil pan, drive plate, flywheel ring gear and engine
mounts, turbocharger housing and internal parts, turbocharger valves and actuator,
radiator, fan and fan coupling, fan motor, water pump, and seals and gaskets.
TRANSMISSION:
Transmission case(s) and all internal parts including the torque converter, vacuum
modulator, electric control units, oil pan, transmission mounts, transfer case and all
internal parts, and seals and gaskets.
FRONT WHEEL DRIVE:
Final drive housing and all internal parts, constant velocity joints (slide joint spider
assemblies), and seals and gaskets. Note: constant velocity boots are excluded from
coverage.
FUEL:
Fuel pump(s), electro injection unit, electronic fuel injection sensors, control units,
injectors, fuel tank and lines, and seals and gaskets.
REAR WHEEL DRIVE AND FOUR WHEEL DRIVE:
Rear drive axle housing and all internal parts, propeller shaft(s), universal joints (journal
assemblies), axle shafts, axle bearings and retainers, free running hubs, constant
velocity joints (spider assemblies), and seals and gaskets. Note: constant velocity
boots are excluded from coverage.
SUSPENSION:
Strut assemblies except inserts, upper and lower control arms (links/transverse links)
and bushings, tension/compression rods and bushings, stabilizer bars and bushings,
connecting rods and bushings, rear arm assembly, torsion bars, upper and lower ball
joints, wheel bearings and seals, knuckle spindle, hubs, king pins and bearings, front
coil and leaf springs.
STEERING:
Steering gear housing(s) and all internal parts, rack and pinion assembly, power
steering pump, steering column main and upper shafts, steering linkages and
couplings, HICAS power cylinder assembly and all internal parts, and seals and
gaskets.
ELECTRICAL:
Starter motor and solenoid, alternator, voltage regulator, ignition coil, distributor,
ignition switch and module, transistor ignition unit, electronic spark control detonation
sensor and controller, wiring harness, horn and windshield wiper motor.
BRAKES:
Master cylinder, vacuum assist booster, wheel cylinders, disc calipers, hydraulic
valves, lines and fittings, and seals and gaskets.
NISSAN AIR CONDITIONING (ORIGINAL EQUIPMENT MANUFACTURER
ONLY):
Compressor, clutch and pulley, condenser, evaporator, receiver dryer, and seals and
valves.
310
To Next Page
Loading...
