[ Edit: 2012/ 4/ 9 Model: E26-A ]
Rear-facing:
GUID-896AA31A-81D 0-4E9B-81ED-1F58D53AA854
SSS0375A
When you install a rear-facing child restraint system on
the rear seat, follow these steps:
1. Position the rear-facing child restraint system on
the rear seat.
Always follow the child restraint system manufac-
turer’s instructions for installation and use.
2. Route the seat belt tongue through the child
restraint system and insert it into the buckle until
you hear and feel the latch engage.
SSS0513
To prevent slack in the lap belt, it is necessary to
secure the shoulder belt in place with a locking
clip
*
A
. Use the locking clip or another locking
device attached to the child restraint system.
Be sure to follow the child restraint system
manufacturer’s instructions for belt routing.
3. Test the child restraint system before you place
the child in it. Tilt it from side to side. Try to tug it
forward and check if it is held securely in place.
4. Make sure that the child restraint system is
properly secured prior to each use.
Installation on rear seats - two-point type seat
belts
GUID-A7AC2B99-0E88-417D-B25B-E103A45CCFB5
WARNING:
. NISSAN recommends that the child restraint
system be installed in a seat equipped with
the three-point type seat belt.
. The direction of the child restraint system
depends on the type of the child restraint
system and the size of the child.
Front-facing:
GUID-896AA31A-81D 0-4E9B-81ED-1F58D53AA854
SSS0512
If you must install a front-facing child restraint system
on the rear center seat equipped with the two-point
type seat belt, follow these steps:
1. Position the front-facing child restraint system on
the rear center seat.
Always follow the child restraint system manufac-
turer’s instructions for installation and use.
2. Route the seat belt tongue through the child
restraint system and insert it into the buckle until
you hear and feel the latch engage.
SSS0513
3. To prevent slack in the lap belt, it is necessary to
secure the lap belt in place with a locking clip
*
A
.
Use the locking clip or another locking device
attached to the child restraint system.
Be sure to follow the child restraint system
manufacturer’s instructions for belt routing.
4. Test the child restraint system before you place
the child in it. Tilt it from side to side. Try to tug it
forward and check if it is held securely in place.
5. Make sure that the child restraint system is
properly secured prior to each use.
Safety — seats, seat belts and supplemental restraint system 1-13
To Next Page
Loading...