[ Edit: 2012/ 4/ 9 Model: E26-A ]
4-8 Heater and air conditioner, and audio system
3. Press the manual tuning button while the
station select buttons
and are being
pressed.
For Central/South America specification, the display
indicates “AM 530 kHz”.
For the other specification, the display indicates “AM
531 kHz”.
If you experience difficulties in changing radio speci-
fication, contact a NISSAN dealer.
Radio band select button:
GUID-896AA31A-81D 0-4E9B-81ED-1F58D53AA854
When the button is pushed while the audio
system is off, the audio system will turn on and the
radio will turn on.
To change the radio bands, push the
button until
the desired band appears.
The FM stereo indicator “ST” will display during FM
stereo reception. When the stereo broadcast signal is
weak, the radio will automatically change from stereo
to monaural reception.
Tune buttons:
GUID-896AA31A-81D 0-4E9B-81ED-1F58D53AA854
When adjusting the broadcasting station frequency
manually, push the
or button for less than 1
second until the desired frequency is achieved.
When adjusting the broadcasting station frequency
automatically, push and hold the
or button
for more than 1 second. When the system detects a
broadcasting station, it will stop at the station.
Station memory buttons:
GUID-896AA31A-81D 0-4E9B-81ED-1F58D53AA854
The audio system can store up to 5 station frequencies
for each band.
To store the station frequency:
1. Tune to the desired broadcasting station fre-
quency by using the
/ button.
2. Push and hold a radio memory button
-
.
3. The channel indicator will display indicating that
the memory is stored properly.
4. Perform steps 1 - 3 for all other memory buttons.
If the battery cable is disconnected, or if the audio fuse
blows, the radio memory will be erased. In such a case,
reset the desired stations.
To Next Page
Loading...