Specification
Input: DC 5V 2A
Output Voltage: Slot 1 8.4V±1% Slot 2 8.4V±1%
Output Current: 1000mA (MAX)
Interface: Input: USB
Output: connector
Compatible camera model:
X-H1, X-Pro3, X-Pro2, X-Pro1, X-T3, X-T2, X-T1, X-T30, X-T20, X-T10, X-T100, X-E3,
X-E2S, X-E2, X-E1, X-M1, X-A7, X-A5, X-A3, X-A2, X-A1, X-A10, X100F, X100V, X-T200, X-S10, X-E4
FinePixHS50EXR / HS30EXR / HS33EXR (and more compatible models)
Size: 3.35” ×1.97” ×1” (85mm×50mm×25.5mm)
Weight: 2.05oz (58g)
Operating Instructions
This product is designed specifically for Fujifilm NP-W126/NP-W126S batteries. It supports charging batteries in both
slots simultaneously. The output current is adjusted automatically according to input current to reach the optimal
charging setting. This product shall NOT be used with other batteries not specified in this manual.
Automatic Current Adjustment
The FX1’s actual output current depends on the maximum power supplied from the USB power source. The output
current will be adjusted based on the actual power being inputted to the device. The FX1 is capable of outputting
1000mA in maximum, increasing its efficiency
Battery Health Monitoring
Once the battery is inserted, the FX1 will proceed with an initial low current test charge to diagnose the battery
status. After the diagnosis, the battery status will be shown as Good, Normal or Poor.
Note: Re-insert the battery when “Poor” appears on screen to eliminate the possibility of a poor battery contact.
Replace the battery if “Poor” comes up on screen consistently.
Reverse Polarity and Anti-Short Circuit Protection
The FX1 makes use of the mechanical reverse polarity protection. Inserting incompatible batteries or incorrect
battery installation will prevent the initiation of the charging process.
Over Discharged Battery Activation
The FX1 will automatically activate over discharged battery caused by improper storage or misuse.
NOTE: This function is only available for batteries with a protective circuit.
Cautions
1. The FX1 is only compatible with Fujifilm NP-W126/NP-W126S camera batteries. DO NOT attempt to charge
other batteries.
2. Moderate heat from this product is to be expected during the charging process, which is
3. Operating temperature: -10°~ 40°C, storage temperature: -20° ~ 60°
4. Carefully read all labels on the device to ensure batteries are installed
5. DO NOT charge batteries if there is any sign of faulty or short
6. The charger is designed for Use of the charger by kids under age must be under supervision. Operation, using
or cleaning of the charger may NOT be done by kids aged 8 years or younger.
7. DO NOT leave the product unattended while it is connected to a power Unplug the product at any sign of
To Next Page
Loading...
Need help?
General
