Nitecore HU60 - User Manual

Biking Accessories for HU60 User Manual
HU60
自行车配件使用说明
Bike Mount
Installation Instructions
1. Hold the Unlock Pedal on the original bracket and pull
out the HU60 as illustrated in diagram (1) to dismount it
as in diagram (2).
2. Hold the Unlock Pedal on the bike mount and install the
HU60 as illustrated in diagram (3) until a click sound is
heard.
3. Loosen the Screw ① with the hex key and tighten it
after securing the bike mount on the handlebar.
Note: The mount pad of the bike mount is removable. It
is compatible with the handlebar diameter of 31.8mm with
the mount pad and 35mm without it.
Dismount Instructions
Hold the Unlock Pedal on the bike mount and pull out the
HU60 as in reverse in diagram (3) to dismount it.
自行车夹
自行车夹安装方法：
1.按住 HU60 头灯带支架上的解锁拨片，然后按照图（1）
箭头所示方向拉出 HU60，即可卸下头灯带支架，如图（2）。
2.按住自行车夹上的解锁拨片，然后按图（3）箭头所示方
向装入 HU60，直至听到“咔”的一声。
3.使用六角匙拧开螺丝①后，在车把合适位置装上自行车夹
并调整好角度，再拧上螺丝①即可。
（注：自行车夹上的软胶垫可拆卸。装上软胶垫时适合
31.8mm 车把，拆卸软胶垫后适合 35mm 车把。）
自行车夹拆卸方法：
按住自行车夹上的解锁拨片，然后按图（3）箭头所示反方
向拉出 HU60 即可。
（ 1 ） （ 2 ）
（ 3 ） （ 4 ）
按住解锁拨片
螺丝①
按住解锁拨片
Hold the Unlock Pedal
Screw ①
Hold the Unlock Pedal

Summary

Bike Mount Instructions

Bike Mount Installation

Guide for attaching the HU60 to the bike mount, including steps and notes on compatibility.

Bike Mount Dismount

Steps to remove the HU60 from the bike mount.

Helmet Strap Instructions

Helmet Strap Installation

Instructions on how to attach the HU60 to a helmet using the helmet strap and hook-and-loop fastener.

Helmet Strap Quick Release

Note regarding the HU60's quick release capability from the helmet strap.

Nitecore HU60 Specifications

General

Brand	Nitecore
Model	HU60
Category	Bicycle Accessories
Language	English