USB OUTPORT PORT
150-23508-001 Rev A
PRO 2800 ENDURO REMOTE
PRO 3600 ENDURO REMOTE
USER GUIDE
BATTERY CHARGING AND CARE
1. Plug the AC Adapter into an electric outlet, then plug the cable
from the AC Adapter into the battery.
2. The LED indicator on the battery will turn red while the battery
is charging. When the battery is fully charged, the LED will
turn blue.
3. Unplug the AC Adapter from the battery by grasping the
connectors rather than the cable.
4. Always store your battery away with a full charge.
For extended periods, charge the battery every three months
to maximize its lifespan.
USB OUTPUT PORT
Your battery pack is equipped with a USB output port for
convenient recharging of electronic devices.
1. Plug in your USB adapter cord (not supplied) into USB output
port, then connect your electronic device to charge.
Please note to power o lighting system before recharging your electronic device
RUN TIMES
RIDING AT NIGHT
While a Pro 2800 / 3600 Enduro lighting system will improve your
view, control and enjoyment of night riding, please remember that
cycling at night is an inherently dangerous activity. In addition to
using your lighting system properly and riding with extreme
caution, NiteRider
®
urges you to:
• Never ride alone
• Always let someone know where you are going
• Wear a helmet and reective clothing
• Carry an auxiliary light and emergency supplies
• Make sure the headlamp, mounting bracket
and battery are securely fastened
• Always disconnect the battery from the headlamp
when transporting the light system
PROTECTING YOUR INVESTMENT
Properly charge your battery to maximize its lifespan (see the
“Battery Charging and Care” section for detailed information).
The Pro 2800 / 3600 Enduro will perform in wet weather
conditions, but submerging it in water will damage the system.
SUPPORT
If you experience diculties during product installation or
operation, NiteRider
®
provides free telephone support on
weekdays from
8:00 am to 4:30 pm (Pacic Time) at 800.466.8366, Ext 4.
You may also e-mail us at support@niterider.com.
WARRANTY
NiteRider
®
stands behind its products with the following
warranties:
• Lifetime warranty: Covers any defects in material
and workmanship, mechanical components (housings, covers,
mounts and fasteners) and LEDs
• 2-year warranty: Printed circuit boards, switches,
and AC adapters
• 1-year Warranty: Rechargeable battery cells
To obtain warranty service have your original sales receipt.
Contact the NiteRider
®
Customer Service
Department at 800.466.8366, Ext. 4 to obtain a Return
Merchandise Authorization (RMA) number. The RMA number
must be prominently displayed on the outside of your package.
The product must be properly packaged to prevent damage
in transit.
For complete warranty information, please visit our website
at www.NiteRider.com
NiteRider
®
Technical Lighting Systems, Inc.
8295 Aero Place, Suite 200
San Diego, CA 92123
www.NiteRider.com
*Run times are approximations and will vary.
**Race mode is intended for endurance races.
PRO 2800 Enduro Remote
Low 6:00h 825 Lumens
Med 3:00h 1400 Lumens
High 1:30h 2800 Lumens
Flash >56:00h
Race 17:00h 375 Lumens
Walk 56:00h 125 Lumens
PRO 3600 Enduro Remote
Low 6:00h 1000 Lumens
Med 3:30h 1800 Lumens
High 1:30h 3600 Lumens
Flash >16:30h
Race 16:30h 450 Lumens
To Next Page
Need help?
General
