Nitho DRIVE PRO V16 - PC Usage and Configuration; X-INPUT;D-INPUT Mode Switching; Driver Uninstallation Procedure

PC GUIDE
1、 The wheel is set on X-INPUT as default.
2、Press & hold HOME for 3 seconds to switch to D-input then the LED will
switch o and switch on again aer 0.5 seconds
· X-INPUT
1、 Enter Test interface to test buttons and axis functions
2、Enter Calibration interface to calibrate the axis
· TEST
1、 Start→ Control Panel→ programs/Function
2、Find the driver you want to remove in the Interface ”current installed programs”.
Click “Remove” and follow the instructions to get the successful uninstall.
· DRIVER UNINSTALL