FUNCTION INTRODUCTION
1、Here below are the DEFAULT buttons (the ones you can assign to other functions):
□/1/X, ○/3/B, △/4/Y, X/2/A, L1/5/LB, L2/7/LT, R1/6/RB, R2/8/RT
2、Here below are the PROGRAMMABLE buttons (the ones you can setup):
L-Wing (L2/7/LB), R-Wing (R2/8/RB), Accelerator Pedal (X/2/RT), Brake Pedal
(□/1/LT), L3/11/SL, R3/12/SR
· INTRODUCTION
1、 Press & hold PROG for 3 seconds until the green LED turns on
2、Press the PROGRAMMABLE button until the green LED starts blinking
3、Press the DEFAULT button until the green LED turns o
· PROGRAM SETUP
1、 Press & hold PROG for 3 seconds until the green LED turns on
2、Press the programmed button until green LED will start blinking
3、Press the programmed button again and the green LED will turns o
· CLEAR SINGLE PROGRAM
1、Press & hold PROG for 3 seconds until the green LED turns on
2、Press & hold “OPTIONS/10/Menu” for 4 seconds until the green LED turns
o. All the programmed buttons are cleared
Note:
All settings will NOT be cleared when the wheel is powered o
· CLEAR ALL PROGRAMS
PROGRAM FUNCTIONS
You can assign to some buttons (Programmable) functions of other buttons (Default)
To Next Page
