As temperatures rise, the traveled distance by the vehicle will also increase. You can check the
remaining distance in the Application.
Note: A fully charged scooter has about 120-180 days of standby time. The battery contains a smart
chip that stores information about its charging and discharging cycles. If you do not charge the
battery for an extended period, it can cause serious damage, for which it is impossible to charge the
device again. This type of damage is not covered by the free warranty service. (Caution: Do not
disassemble the device by unauthorized individuals, as there is a risk of electric shock or serious
injury due to a short circuit.)
Adjusting the disc brake
If the brake is too tight, use the supplied hex wrench to loosen the screws on the caliper. Then, slightly pull
back the brake cable to shorten its length, and tighten the screws afterwards. If the brake is too loose, loosen
the screws slightly and pull out the brake cable to lengthen it. Finally, tighten the screws once adjustments are
made.
Adjusting the handle bar
If the handlebar and its stem sway during riding, use the supplied hex wrench to tighten the screws
on the folding mechanism.
Using a connecting pipe to pump wheels
If the wheel of the Electric Scooter deflates, connect a connecting pipe to the wheel nipple to
pump it. First, remove the cap from the pin, then tighten the fitting, and finally, begin pumping
the wheel
To Next Page
Loading...
