ตัวอย่างการเข้าทำรายการ Cumulate Clear
2
3
4
5
6
1
Basic Setup
Bas Sys Trim CHK
PV Decimal
Total Decimal
Damping(s)
Lcd Rotate
SYSTEM SETUP
Bas Sys Trim CHK
Signal
→
Pulse Output →
MODBUS Output
→
Clear Total
Load Settings
No
Bas Sys Trim CHK
Signal
→
Pulse Output →
MODBUS Output
→
Clear Total
Load Settings
Bas Sys Trim CHK
Yes
No
Clear Total
Clear Total
OK:C/CE
CANCEL:
→
Bas Sys Trim CHK
Yes
No
Clear Total?
Yes: C/ CE No:
→
Bas Sys Trim CHK
No
Cumulate Clear
Steps Operation instructions
Interface show
Modify value
Current value
Two ways of the total cumulative flow, its meaning is as follows
1 Σ +, means symbol "+ 'cumulative value of the flow
2 Σ- ,means symbol ' - " cumulative value of the flow
Select cumulate cleared, the total amount of the above two are forced to zero, cannot be recovered
if don’t save before. Clear cumulate as follows
Click “C/CE” two times from
measurement mode into BAS
configuration menu
Click “→” to choice “sys” item
Click “↓” to choice “Clear Total”
item
Click “→” into Clear Total menu, click
“↓” to setup value of clear total
Click “C/CE” quit setup menu ,
LCD show confirm menu
Click “C/CE” again into “Clear total ”
confirm menu, if click “→”, quit “Clear
total” stage
To Next Page
Loading...