Need help?Do you have a question about the Nitto FLOWTECH KF-700 Series and is the answer not in the manual?
General| Brand | Nitto |
|---|---|
| Model | FLOWTECH KF-700 Series |
| Category | Measuring Instruments |
| Language | English |
Proper placement for upstream/downstream straight pipe runs and pump clearance.
Guidelines for grounding metal and non-metal pipes with ground rings.
Connecting AC220V and DC24V power supplies, and ground terminals.
Wiring for analog (4-20mA) and digital (0-2KHz, RS485) outputs.
Explanation of symbols and numerical indicators on the flowmeter display.
Understanding the buttons and their functions for operation.
Step-by-step guide to change instantaneous flow rate units.
Step-by-step guide to change total accumulated flow units.
How to set the direction for total accumulated flow measurement.
Configuration of damping, decimal points, and LCD rotation.
Settings for signal, pulse output, MODBUS, and clearing total.
Performing tube trim, loop trim, zero trim, and manual adjustments.
Testing output signals using loop and pulse tests.
Navigating to and entering basic setup parameters.
Navigating to and entering system settings.
Navigating to and entering calibration parameters.
Navigating to and performing instrument tests.
Step-by-step guide to modify the damping time parameter.
Step-by-step guide to configure the flow direction parameter.
Procedure for resetting the total accumulated flow values.
Procedure to calibrate flow rate by modifying the K-Factor.
Formula and example for calculating an updated K-Factor.
To Next Page