Nitto FLOWTECH KF-700 Series - Flow Direction Settings; Setting Flow Direction

1
Basic Setup
Bas Sys Trim CHK
PV Decimal
Total Decimal
Damping(s)
Lcd Rotate
Steps Operation instructions
Interface show
Click “C/CE” two times from
measurement mode into
configuration menu
2
3
4
5
6
7
8
SYSTEM SETUP
Bas Sys Trim CHK
Signal
→
Pulse Output →
MODBUS Output
→
Clear Total
Load Settings
SYSTEM SETUP
Bas Sys Trim CHK
Signal
→
Pulse Output →
MODBUS Output
→
Clear Total
Load Settings
Bas Sys Trim CHK
Direction
Fwd
Bid
9
Bas Sys Trim CHK
Max Limit%
Limit Time(S)
Direction
282.743
Qmax(
m
3
/h
)
Bas Sys Trim CHK
Max Limit%
Limit Time(S)
Direction
Bid.
Qmax(
m
3
/h
)
Click “C/CE” three times to back measurement mode, you also can
continue other operation.
Click“→”enter direction , press use
“↓”to set direction
Click “C/CE” quit setup menu ,
LCD show confirm menu
Click “C/CE” ,confirm and save
configure ,after return configure option
menu,(click “→” to give up modify. )
Modify value
Current value
Click “→” to choice “sys” item
Click “↓” to choice “Signal” item
Click “→” into signal handle menu
Click “↓” to choice Direction item
Bas Sys Trim CHK
Max Limit%
Limit Time(S)
Direction
Fwd
Qmax(
m
3
/h
)
OK:C/CE
CANCEL:
→
Bas Sys Trim CHK
Fwd
Bid
ตัวอย่างการเข้าทำรายการ Flow Direction
หมายเหตุ การปรับ Flow Direction จำเป็นต้องปรับ Indication ให้ทิศทาง สอดคล้องกัน
ไม่เช่นนั้นค่า Flow rate ด้านหน้า ติด (-)