User Operation and Controls Section 2
February 2010 Digital Talking-Book Player 24
Library Guide
2.3.2 AT Device Learning Mode
The player can be instructed as to which controls on the AT device are to operate particular player functions. This
assignment is performed through a learning process.
Entering AT Device Learning Mode
Connect the AT device to the USB port on the side of the player.
To enter the learning mode press and hold the Sleep button for 5 seconds
while in Key Describer mode (the player is on but has no cartridge
inserted). An AT device must be connected to the player in order to enter
learning mode. If no AT device is found, the message “No remote control
device found. Ensure your remote control device is connected before
entering learning mode” is played. The player then returns to Key
Describer mode.
Press and hold for 5
seconds
Sleep
Initiating AT Learning Sequence
Audio prompts will lead the user through the learning sequence. The first
prompt asks the user to press the Fast Forward button to start the learning
process or the Power button to exit.
then press
FF
Assigning Player Functions to the AT Device Buttons.
Player controls are assigned
by first pressing the button
on the player then pressing
the control on the AT
device that is to be assigned
that function.
This is repeated for all
controls to be assigned.
Press the player button to be
assigned (example: Play)
then
Press the control
on the AT device
to be assigned
Play
Exit AT Learning Sequence
Press the Power button to exit the learning mode.
If an assignment has been started but not completed, pressing the Power
button will cancel the assignment. The player will remain in AT learning
mode.
Press to exit
Power
To Next Page
Loading...