Special Features for Libraries and Technicians Section 3
Battery
Battery Settings and Statistics
Note: There may be a delay in updating the battery status information after adding, removing, plugging,
unplugging, or resetting a battery; after plugging or unplugging the player; and after initiating a manual
recharge. Some extreme scenarios may require 5 minutes to produce the expected status announcement. If
you get unexpected results, retry another battery status 5 minutes later to confirm the results.
Statistics
Report the number of battery charge cycles for the current battery and the current software version.
Response
The player announces “Number of battery charge cycle X,” “Version Y” where
X is the number of battery recharges = number of times the current battery has been recharged
(less than 25 percent + between 25 percent and 50 percent + between 50 percent and 75 percent
+ between 75 percent and 100 percent).
Y is the current software version number of the player.
The player then announces the current menu item “Battery.”
Initiate Battery Recharge
The player starts charging the battery regardless of the battery’s charge state.
Note: It takes at least 5 seconds before the status is updated. If the status is queried before that 5
second delay elapses, the result will be inaccurate.
Response
The player announces “Recharge initiated.”
The player then announces the current menu item “Battery.”
Recharge Status
Determine battery status.
Commands
Response
If the battery is not detected, the player announces “Battery not detected.”
If the battery recharge is in progress, the player announces “Battery recharge in progress.”
If the battery recharge is complete, the player announces “Battery recharge completed.”
If any other problem is detected, the player will announce “Power error.”
The player then announces the current menu item “Battery.”
February 2010 Digital Talking-Book Player 40
Library Guide
To Next Page
Loading...