YOU’LL NEED: H5 ALLEN WRENCH
Remove the two screws from the bracket to separate the Speaker pod and the bracket.
YOU’LL NEED:
3″ (76 mm) pads.
Remove the backing off the pad and place it in the inner side of both the pod and the mounting bracket.
YOU’LL NEED:
6″ (150 mm) pads.Remove the backing off the pad and wrap it around the bar. The pad should go all the way around the bar. if the pad is too
long, cut the extra length. the glue on the pad is there only to make installation easier. Holding the speakers is not its purpose!
To Next Page
Loading...
