NUTV4QUAD
4 Channel Marine 4″ UTV/ATV/BOAT Audio System with Bluetooth®
Two Pair 4″ 2-Way Marine Speaker:
• 4″ High-Quality Poly Injection Cone
• Butyl Rubber Surround
• Shiny Black Plastic Enclosure
• Fits 1.5″-2″ Bars
• 1″ High-Temperature KEISV Voice Coil
• 1″ PEI Neodymium Dome Tweeter
• 100 Watts
• Frequency Response: 100-20KHz
• Impedance: 4 Ohms
4 Channel Marine Power Amplifier
• 4 x 100 Watts at 4 Ohms
• Anti-Thump Turn-On
• Soft Turn On/Off
• Bluetooth”° Streaming
• AUX Input
• Volume Gain Remote Control
• T.H.D: <0.05%
• S/N Ratio: >95dB
• Channel Separation: >65dB
• Frequency Response: 10Hz- 30kHz
• Fuse : 11xx 20A
• Bluetooth® 3.0 Technology
• Bluetooth® Auto Connected While Power on
• Bluetooth® Auto Disconnected While Aux-in (3.5mm Connector)
• Easy and Quick Installed Handle-bar Mount Bracket is Included
• Bluetooth® Console Dimension: 2.12″(W) x 1.16″(H) x 3.83″(L)
• Amplifier Dimensions: 6.3″L x 3.67″W x 2.11 “H
What is included?
When first unpacking your new amplified Marine speaker system, Please check first that the package contains all of the items below. If
something is missing, contact the store where you purchased the product.
NUTV4 QUAD
• Two Pair4″ 2 Way Marine Speaker
• One Piece 4 Channel Marine Power Amplifier
• One Piece Bluetooth°controller
Installation precautions
Before you drill or cut any holes, investigate your vehicle’s layout very carefully. Take special care when you work near the gas tank, fuel lines,
hydraulic lines and electrical wiring. Never operate the amplifier when it is unmounted. Attach all audio system components securely within the
amplifier to prevent damage, especially in an accident. Do not mount this amplifier so that wire connections are unprotected. in a pinched
condition, in contact with any metal surfaces in your vehicle, or likely to be damaged by nearby objects. Before making or breaking power
connections in your system, disconnect the vehicle battery. Confirm that your head unit or other equipment is turned off while connecting the
input jacks and speaker terminals. If you need to replace the power fuse, replace it only with a fuse identical to that supplied with the amplifier,
Using a fuse of a different type or rating may result in damage to your audio system or your amplifier which is not covered by the
manufacturer’s warranty.
SPEAKER INSTALLATION INSTRUCTIONS:
Please note: The below instructions refers to most common bar sizes; 1.5″, 1.75″ and 2″
but using the supplied rubber pads will allow you to mount these speakers on any bar size measured between 1.5″ and 2″
To Next Page
Loading...