Bluetooth® Pairing and Connection:
1. Connect Bluetooth® controller box to your device
2. Press and Hold % for three seconds until power indicator lights (red)
3. The system will automatically go into pairing mode The power indicator will turn red for about 4-6 seconds and then alternating red and blue
(Bluetooth® blue Power red) Please be sure that Bluetooth®is turned ON. Select NOAM Audio on your device to connect Bluetooth®controller
(if the Bluetooth® controller is connected the light will turn blue and not flash)
4. When the device is out of Bluetooth®range, Bluetooth® will be disconnected automatically and automatically reconnect when detected in
range again. (If not please just repeat steps 2 and 3)
5. When Bluetooth” is disconnected or the 3.5mm AUX Input is plugged in, the power indicator will glow red.
Playing Music:
1. Press and hold for three seconds to turn On/OFF
2. Press shortly in order to control the red background light
3. Press to start or pause the music
4. Press shortly for the next track
5. Press shortly for the Previous track
6. Press shortly for volume up
7. Press shortly for volume down
Bluetooth® Installation (MODE 1″Surface mount”)
1. Install “Z” shaped bracket threaded n to the Bluetooth® controller hook. (packed with Bluetooth®controller.) Use the hole on the other
bracket’s end to mount the controller. any screw/bolt and a washer will allow a clean and easy surface mounting.
2. Slide the Bluetooth®controller into the hook
To Next Page
Loading...
