What to do if my Nobili TB 151 rotor is jamming during work?
If the rotor of your Nobili Paper Shredder jams during operation, it's likely due to clogging from foreign objects like wire or plastic. To resolve this, put on gloves and use appropriate tools to carefully remove any foreign materials that are causing the blockage.
Why is my Nobili Paper Shredder belt overheating?
Belt overheating in your Nobili Paper Shredder can occur if the belt tension is incorrect or if the angle gearbox axle is not aligned with the rotor axle. Ensure that the belt tension is correct. Also, check the alignment of the angle gearbox axle with the rotor axle.
How to fix excessive vibrations in Nobili TB 151 Paper Shredder?
Excessive vibrations in your Nobili Paper Shredder can be caused by several factors: * Breakage or wear of knives or hammer knives: Replace worn or damaged parts. * Knife or hammer knife jamming on the pivot point: Clean and grease pivot points. * Incorrect rotor balance: Check the weight of knives and hammer knives.
What causes poor cutting quality in Nobili TB 151?
Poor cutting quality in your Nobili Paper Shredder, resulting from a drop in rotor speed, can be attributed to insufficient belt tension or excessive belt wear. Adjust the belt tension or replace the belts.
What to do if Nobili TB 151 angle gearbox is overheating?
If the angle gearbox on your Nobili Paper Shredder is overheating, it could be due to a lack of oil or no oil at all. Top up the oil until the proper level is reached, or if there is no oil, replace the gearbox.
Why is there fast knife wear on my Nobili Paper Shredder?
Fast knife or hammer knife wear on your Nobili Paper Shredder is often due to the working position being too low, causing interference with the ground. Adjust the working height to prevent this issue.
How to fix distortion of roller supports on Nobili TB 151 Paper Shredder?
Distortion of the roller or wheel supports on your Nobili Paper Shredder is typically caused by lateral forces. To prevent this, raise the machine off the ground when inverting the direction of travel or steering the wheels.
What causes drive shaft oil loss on Nobili Paper Shredder?
Drive shaft oil loss on the belt side of your Nobili Paper Shredder is likely due to seal wear or breakage. Replace the seal to resolve this issue.
What causes distortion of the front pivoting safety flaps on a Nobili TB 151 Paper Shredder?
Distortion of the front pivoting safety flaps on your Nobili Paper Shredder happens when the machine is lowered onto the residues to shred from the raised (transport) position. Ensure the machine is in the working position before it touches the residues.
General safety guidelines for machine operation and use.
Safety advice for operating the tractor during work and transport.
Specific safety rules for road transport.
Safety for connecting the machine and hydraulic circuits.
Safety guidelines for servicing the machine.
Procedures for attaching and detaching the machine from the tractor.
Steps to prepare the machine for operation.
Guidelines for safe and effective operation of the shredder.
Procedures for checking and replacing cutting tools.
General| Brand | Nobili |
|---|---|
| Model | TB 151 |
| Category | Paper Shredder |
| Language | English |
To Next Page
