Noblelift ACX 10E - User Manual

Questions and Answers

B
Bradley JohnsonAug 12, 2025
What to do if my Noblelift ACX 10E high-lift pallet truck won't lift the load but the pump works?
- E
  Elizabeth MooreAug 12, 2025
  If the high-lift pallet truck from Noblelift doesn't lift the load despite the pump working, it might be due to several reasons. First, the load could be too heavy, activating the overload valve; try reducing the load. Second, the lowering valve may not be closing properly due to dirt or rust, in which case you should clean or replace it. Also, check the wiring, as a disconnected electric circuit could be the cause. A defective electromagnetic contactor KM or an obstructed lifting switch could also be the problem; replace the contactor or check/replace the switch, respectively. Finally, check the pump.
M
Michael IrwinAug 19, 2025
Why is the raised load lowering automatically on my Noblelift ACX 10E?
- V
  Victor RiosAug 19, 2025
  If a raised load is lowering automatically on your Noblelift Lifting Systems, it could be due to a few reasons. There might be a leakage in the hydraulic system, in which case you should replace the seal. Another possibility is that the lowering valve isn't closing properly because of dirt; try cleaning or replacing the valve. Also, the valve set-up might be incorrect, so you should adjust the lowering valve. Finally, the pressure relief valve may have a leakage.
W
Wendy WelchAug 27, 2025
How to troubleshoot a Noblelift ACX 10E with a motor and hydraulic pump that won't operate?
- N
  Natalie AdamsAug 27, 2025
  If the motor and hydraulic pump of your Noblelift Lifting Systems aren't working, start by checking the fuses FU1 and FU2 and replace them if they are defective. Also, make sure that all plugs are securely connected. If these steps don't solve the problem, the motor itself might be defective and require replacement.
G
gloverpeterSep 3, 2025
What to do if there's oil loss on the hydraulic cylinder of my Noblelift ACX 10E?
- K
  Kevin ColemanSep 4, 2025
  If you notice oil loss on the hydraulic cylinder of your Noblelift Lifting Systems, it's likely that the sealing is worn out or defective. You should replace the sealing to resolve this issue.