1. Check your mains voltage is the same as that marked on the rating plate
of the battery charger. Plug the battery charger in the plug socket and
connect the charging cable to the socket. (6)
LED indications:
1. Red LED illumination: Charge the electric screwdriver.
2. Yellow and red LED illuminated: Battery has sufficient charge.
3. All LED illuminated: Battery is fully charged.
If the battery pack fails to charge, please check whether there is voltage at the
socket/ outlet, and that there is proper contact between the tool and the battery
charger points.
If the battery still fails to charge, contact with us at wecare@nocry.com
Timely recharging of the battery pack will increase the battery life of the product.
Never allow the battery pack to become fully discharged, as it might cause defects
in the operation.
Change of direction switch (Fig 2. / Item 4)
The sliding toggle above the ON/OFF switch is for setting the direction of rotation
of the cordless screwdriver, and for preventing the cordless screwdriver from being
switched on inadvertently. You can select between clockwise and counter-
clockwise rotation. Change the direction of rotation only when the equipment is at
a standstill. Failure to do so may damage the gearing. When the toggle is in the
middle position, the ON/OFF switch is blocked.
ON/OFF switch (Fig. 2 / Item 3)
Press the ON/OFF switch to switch the cordless screwdriver on. Release the
ON/OFF switch to switch the tool off.
11
To Next Page