LED lamp
The LED lamp (5) can be used in poor lighting conditions to illuminate the area
where you want to screw.
Torque setting (Fig. 3)
The cordless screwdriver is fitted with a mechanical torque selector. The torque for
a specific size of screw is selected by rotating the front of the screwdriver (2). The
correct torque depends on several factors:
- The type and hardness of the material in question
- The type and length of the crews being used
- the requirements needing to be met by the screwed joints.
The clutch will disengage with a grating sound to indicate when the set torque is
reached.
Changing the tool (Fig. 5)
Important! Set the sliding toggle to the center position whenever you carry out
work (for example changing the inserts, maintenance work, etc.) on the cordless
screwdriver.
Screwdriving
We recommend using self-centering screws (e.g. Torx screws, recessed head
screws) designed for reliable working. Be sure to use a bit that matches the screw
in shape and size. Set the torque, as described elsewhere in these operating
instructions, to suit the size of the screw.
12
To Next Page