nokia
CONNECTING PEOPLE
PAGE 11 (17) Approved 1.0
Nokia Mobile Phones Customer Care EMEA
SQX 00617-en DJK
Technical Services, Repair Concepts Confidential 17.03.2003
Remove the VIBRA MOTOR with the rubber from its
guidance.
Lift the MICROPHONE from its guidance forcefully,
because it is stuck into its guidance. Use a straight bladed
screwdriver for this procedure.
Use SRT-3 to release the BATTERY CONNECTOR from the
main frame.
The SIM STOPPER is attached with snaps. Use tweezers to
release the snaps.
If it is needed to change the SPEAKER, release the TORX
PLUS® screws size 6 as shown in the picture. When
assembling use a torque of 8Ncm.
Open the snaps with SRT-6 on both sides of the LCD
METAL SHIELD.
The SPEAKER can be changed separately. To remove it
from the LCD Housing, push it with SRT-6. Do not
damage the spring contacts.
If it is needed to change the ANTENNA, use tweezers to
release the snap fixings by pushing slightly. The ANTENNA
is attached with four snap fixings in its guidance. One of
the snaps cannot be released. See picture up there.
Service Manual 2100 Level 1&2 Copyright 2002-2003 © Nokia Corporation
To Next Page
Loading...
