NOKIA 32 ANALOG FAX
QUICK GUIDE
1 (3)
1. ANALOG FAX QUICK GUIDE FOR THE NOKIA 32 TERMINAL
The Nokia 32 terminal supports group 3 analog fax connection according to ETSI TS 100931 v8.0.1.
standard with maximum of 9600 bit/s. The analog fax feature is an addition to the product functionality
and is supported with the following or newer software:
• 8.75 TME-3 (Nokia 32 GSM module)
• 5.03 DTX-3 (Nokia 32 application module)
1.1 Connecting analog fax to Nokia 32 terminal
Connect the analog fax to the trunk connector of the Nokia 32 terminal.
1.1.1 Connecting cable
Use a 2-wire cable between the analog fax machine and the Nokia 32 terminal. If you use a 4-pin RJ-11
cable, connect only the pins 2 and 3, as shown in picture 1. If you use a 6-pin RJ-11 cable, connect only
the pins 3 and 4, as shown in picture 2. In both pictures, the coloured lines represent the connection to
the pins in the trunk connector of the Nokia 32 terminal.
Note that even though RJ-11 connectors have 4 or 6 pins, only 2 wires can be connected, as shown
below.
To Next Page
Need help?
General
