be fully compatible with this device. Incompatible
cards may damage the card and the device and corrupt
data stored on the card.
1. Switch the phone off, and remove the back cover
and the battery of the phone.
2. Slide the memory card holder to unlock (1).
3. Open the card holder (2), and insert the memory
card into the card holder with the contact surface
facing inwards (3).
4. Close the card holder (4), and slide the card holder
to lock it (5).
5. Insert the battery, and attach the back cover to the
phone.
Charge the battery
The exact charger model number may vary depending
on the type of plug. For example, the model numbers
for the AC-3 charger can be AC-3C, AC-3U, AC-3X, etc.
Warning: Use only batteries, chargers, and
enhancements approved by Nokia for use with this
particular model. The use of any other types may
invalidate any approval or warranty, and may be
dangerous.
For availability of approved enhancements, please
check with your dealer. When you disconnect the
power cord of any enhancement, grasp and pull the
plug, not the cord.
1. Connect the charger to a wall socket.
2. Connect the lead from
the charger to the
socket on the bottom
of your device.
If the battery is
completely discharged, it
may take a few minutes
before the charging
indicator appears on the
display or before any calls can be made.
The charging time depends on the charger used.
Charging a BL-4C battery with the AC-4 charger takes
approximately 1 hour while the device is in the standby
mode.
Antenna
Note: Your device may have internal
and external antennas. As with any radio
transmitting device, avoid touching the
antenna unnecessarily when the antenna is in
use. Contact with such an antenna affects the
communication quality, may cause the device
to operate at a higher power level than
11
To Next Page
Loading...
Need help?
General
