447R
10
1.6. Monitor Connection
Make sure that the monitor is disconnected from mains and the power switches of
the computer and all attached devices are turned off before connecting the monitor.
- Connect the signal cable plug to the videocontroller connector at the back of the computer.
- Tighten the screws on the plug by hand.
- Connect the power cord first to the monitor and then to a grounded power outlet.
1.4.1. If your monitor is DDC compatible (PC)
- Do not use any adapter when connecting signal cable to your computer.
- Do not extend the signal cable with extension lead. The DDC signals will not accept extended
cable.
1.4.2. If there is no DDC in your computer (PC)
- Normally there is no need for adaptor when connecting signal cable to your computer.
- Use MAC adaptor in signal cable when connecting the monitor to an A pple
Macintosh computer.
- If the computer is equipped with separate display adapter card. It may have a standard
D---SUB connector. In that case MAC adaptor is not needed.
Signal connector
Pin Signal
1--->RVRedvideo
2 ---> GV Green video
3 ---> BV Blue video
4 < --- ID2 (grounded)
5 Signal cable plugged/unplugged
6 RG Red ground
7 GG Green ground
8 BG Blue ground
9 ---> DDC +5V
10 LG Logic ground
11 < --- ID0 (Grounded)
12 < --- SDA DDC SDA
13 ---> Hs Horiz ontal sync., Composite sync.
14 ---> Vs Vertical sync.
15 < --- SCL DDC SCL
1
5
6
10
11 15
To Next Page
Loading...
