Get started
4 Copyright © 2005 Nokia. All rights reserved
Press and hold the end key.
If the phone asks for a PIN or a UPIN code, enter the code (displayed as
****), and select OK.
Plug and play service
When you switch on your phone for the first time, and the phone is in the
standby mode, you are asked to get the configuration settings from your
service provider (network service). Confirm or decline the query. See
Connect to service provider support in "Configuration", p. 51 and
"Configuration settings service", p. xii.
■ Normal operating position
Use the phone only in its normal operating position.
Your device has an external antenna.
Note: As with any other radio
transmitting device, do not touch the
antenna unnecessarily when the device
is switched on. Contact with the
antenna affects call quality and may
cause the device to operate at a higher
power level than otherwise needed.
Avoiding contact with the antenna area when operating the
device optimizes the antenna performance and the battery life.
To Next Page
Loading...
