Nokia 6600 - Starting an Application Using a Voice Command

Copyright © 2004 Nokia. All rights reserved.
125
3. Say the voice command. The phone will stop recording after approximately 5
seconds.
4. After recording, the phone plays the recorded command and the note Playing
voice command is displayed. If you do not want to save the recording, press
Quit.
5. When the voice command has been successfully saved, the note Voice
command saved is displayed and a beep sounds. A symbol can be seen next
to the application.
Adding an application to the list
Assign voice commands to other applications that are not listed in the Voice
commands main view.
1. In the Voice commands main view, select Options→ New application.
2. Available applications are displayed. Scroll to the application that you want to
add and press Select.
3. Add a voice command to the new application. See ‘Adding a voice command to
an application’, p. 124.
Starting an application using a voice command
1. In standby mode, press and hold . A short tone is played and the note
Speak now is displayed.
2. When you are starting an application by saying a voice command, hold the
phone at a short distance away from your mouth and say the voice command
clearly.