[ 72 ]
Setup voicemail with dialing codes
1
At the
Start screen, press
Names
, scroll to
1-touch dialing
, and
press
Select
.
2
Scroll to an empty 1-touch dialing slot and press
Assign
.
3
Enter your voice mailbox number, including the area code.
4
Refer to the table entitled “dialing codes,” and enter any codes as
necessary using the information that you wrote down earlier.
For example, if you pause for 5 seconds after connecting to voicemail,
enter
p
twice
after
the voice mailbox number, such as 2145551212
pp
.
5
Enter any remaining pauses, PIN codes, and other information that
allows you to listen to your messages, then press
OK
.
6
Enter a name (such as Voicemail) and press
OK
. A message appears in
the display confirming your 1-touch dialing location has been saved.
Now, to dial and listen to your voicemail, just press and hold the
assigned 1-touch dialing key at the Start screen. No other keypresses
should be necessary to connect and listen to your messages.
• MESSAGE OPTIONS
Some or all of the options in the following table are available for text
messages, picture messages, multimedia messages, and e-mail.
1
While viewing a text, picture, multimedia message, or e-mail
press
Options
.
Dialing codes
*
Bypasses a set of instructions
+
Precedes an international telephone number
p
Pauses for 2.5 seconds before sending any numbers that follow
w
Wait. Your phone waits for you to press
t
before it sends any
numbers or codes that follow.
To Next Page
Loading...
