Nokia 6700 Slide
RM-576 / RM-577
Service Manual Level 1&2
24 Confidential
| Copyright © 2010
Nokia | All rights reserved
Version 2.0
4) Carefully press the LCD flex as shown. 5) Turn back the LCD and place it correctly to the
SLIDE MODULE.
6) Place the SS-93 as shown to use it as a guiding
tool for the second bending.
7) Carefully press the LCD flex as shown to bend it
correctly. Before assembling the UI KEYMAT
SUPPORT, check that the LCD flex is correctly
connected to the MAIN FLEX ASSEMBLY.
8) Slide the UI KEYMAT SUPPORT to direction shown.
Make sure that shown two clips are correctly
positioned.
9) Before placing the UI KEYMAT SUPPORT
completely, make sure that the LCD flex is correctly
bended. Place the UI KEYMAT SUPPORT on it's place
so that the LCD flex folds nicely underneath it
To Next Page
Loading...
