Training and Vendor Development
CMO Operations & Logistics
Multimedia Creation & Support CONFIDENTIAL
10.Okt.2006
14
Service Manual 7373 RM-209 Copyright © 2006 NOKIA Corporation. All rights reserved.
Approved 1.0
MGR
Page (26)
9. Also, protect the inner side of the window with a plastic film. 10. Carefully unlock the BOARD TO BOARD CONNECTOR.
11. Unlock four clips at the B-COVER, which hold the UI-SHIELD
into the B-COVER.
12. Do not damage the LCD connector when opening.
13. Open the four clips which hold the LCD into the UI-SHIELD.
Do not bend the clips too much to keep the part reusable for
assembly.
14. Lift out the LCD.
15. To avoid dust and scratches, protect the LCD with a plastic
film.
16. Open the two Torx Plus® size 6 screws in the following order.
For assembly use the reverse order and apply a torque of 25
Ncm +/- 2Ncm. Always use new screws!
To Next Page
Loading...
