Training and Vendor Development
CMO Operations & Logistics
Multimedia Creation & Support CONFIDENTIAL
10.Okt.2006
16
Service Manual 7373 RM-209 Copyright © 2006 NOKIA Corporation. All rights reserved.
Approved 1.0
MGR
Page (26)
DISASSEMBLY INSTRUCTION (LOWER BLOCK)11.
1. Always protect all windows with a plastic film. 2. Remove the E-COVER.
3. If you need to change the KEYMAT, it is also possible at a
closed LOWER BLOCK. Remove the KEYMAT starting exactly from
the point shown.
4. For assembly only:
When assembling, start placing the KEYMAT at button “0” and
move forward to the upper side.
5. For assembly only:
Start placing the KEYMAT at the marked positions.
6. For assembly only:
Be sure to have all clips locked properly.
7. Open the two Torx Plus® size 6 screw in the following order.
For assembly use the reverse order and apply a torque of 25
Ncm +/- 2Ncm.
8. Open the middle snaps of the D-COVER, using a slotted screw-
driver.
To Next Page
Loading...
