Get started
16
Copyright © 2005 Nokia. All rights reserved.
Note: Use normal, plain
paper as found in standard
printers or use a photo
print that is not thicker
than 0.3 mm. To avoid
affecting the antenna
performance the material
must not contain metal
particles.
1. Place the stencil in the correct
position and draw the outline.
2. Carefully cut out your new cut-
out cover.
Tip: The Nokia PC Suite
provides within the image
editor a tool to create cut-out
covers.
■ Changing the cut-out
cover
1. Remove the back cover from the
phone. See ”Changing the covers”
on page 14.
2. Remove the cut-out cover from
the back cover.
3. Place the new cut-out cover into
the back cover by sliding the cut-
out cover under the two guides at
the bottom (1) and then under
the guide at the top (2).
4. Replace the back cover.
To Next Page
Loading...
