Nokia Cellphone 3220 - Call; Phone

Settings
Copyright © 2005 Nokia. All rights reserved. 47
date, and select the date format and
date separator
Auto-update of date & time
(network service) — to set the phone
to automatically update the time
and date according to the current
time zone
■ Call
Select Menu > Settings > Call
settings and from the following
options:
Automatic volume control — to set
the phone to automatically adjust
the speaker volume according to the
background noise
Call divert (network service) — to
divert your incoming calls. You may
not be able to divert your call if some
call barring functions are active. See
Call barring service in ”Security”
p. 50.
Anykey answer > On — to answer an
incoming call, briefly press any key
except the end key and the left and
right selection keys.
Automatic redial > On — to set your
phone to make a maximum of 10
attempts to connect the call after an
unsuccessful call attempt
Speed dialling > On — to activate
speed dialing. To set up speed
dialing, see ”Speed dialing” p. 42. To
dial, press and hold the
corresponding number key.
Call waiting > Activate — to set the
network to notify you of an
incoming call while you have a call
in progress (network service). See
”Call waiting” p. 20.
Summary after call > On — to
briefly display the approximate
duration and cost (network service)
of the call after each call
Send my caller ID (network
service) > Yes, No, or Set by network
Line for outgoing calls (network
service) — to select the phone line 1
or 2 to make calls if supported by
your SIM card
■ Phone
Select Menu > Settings > Phone
settings and from the following
options:
Phone language — to set the display
language of your phone. If you select
Automatic the phone selects the
language according to the
information on the SIM card.
Memory status — to view the free
memory and the used memory in
Gallery and Messages
Automatic keyguard — to set the
keypad of your phone to lock
automatically after a preset time
delay when the phone is in the
standby mode and no function of the
phone has been used. Select On, and
you can set the time from 5 seconds
to 60 minutes.