E-mail support
3
Copyright © 2006 Nokia. All rights reserved.
E-mail support
The purpose of this document is to help you to configure
and use your device when using e-mail with your Nokia
E60. It walks you through defining the right settings for
your e-mail account and discusses some common
problems that can be caused by wrong settings.
To receive and send e-mail, you must have a remote
mailbox service. This service may be offered by an Internet
service provider, a network service provider, or your
company. Your device is compliant with Internet standards
SMTP, IMAP4 (revision 1), and POP3, and with different
push e-mail solutions. Other e-mail providers may offer
services with different settings or features than those
described in this user guide. Contact your e-mail provider
or service provider for more details.
Before you can send, receive, retrieve, reply to, and forward
e-mail on your device, you must also do the following:
• Configure an Internet access point (for more
information, see Nokia E60 User Guide).
• Set up an e-mail account, and define the e-mail
settings correctly.
Follow the instructions from your remote mailbox and
Internet service providers. Contact your network and
Internet service providers or operator for the correct
settings.
Creating an e-mail account
If you select Mailbox and have not set up your e-mail
account, you are prompted to do so. To start setting up the
e-mail account with the mailbox guide, select Yes.
1 To start entering the e-mail settings, select Start.
2 In Mailbox type, select IMAP4 or POP3, and select Next.
Tip: POP3 is a version of the post office
protocol that is used to store and retrieve
e-mail or Internet e-mail messages. IMAP4
is a version of the Internet message access
protocol that lets you access and manage
e-mail messages while the messages are
still on the e-mail server. You can then
choose which messages to download to
your device.
3 In My e-mail address, enter your e-mail address. To
insert @ or other special characters, press *. To insert
a full stop, press 1. Select Next.
4 In Incoming mail serv., enter the name of the remote
server that receives your e-mail, and select Next.
5 In Outgoing mail serv., enter the name of the remote
server that sends your e-mail, and select Next.
Depending on your mobile operator, you might have to
use your mobile operator's outgoing e-mail server
instead of your e-mail provider's.
To Next Page
Loading...
