Nokia E7-00 - Initial Setup and Account Creation

Nokia E7-
00
RM-626
Service Manual Level 1&2
16 Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0
19) Remove the QWERTY KEYMAT. 20) Close the device and unscrew the four Torx+ size
4 screws in the order shown. These screws cannot be
used again. Discard them.
21) To release the BACK COVER, insert the SRT-6
between the BACK COVER and the BASE CHASSIS. Then
slide the SRT-6 to the direction shown. Do this ONLY
on LOCK KEY side!
22) Lift up and remove the BACK COVER.
23) Lift up the BATTERY with the SRT-6 and remove it.
24) Open the device as shown. Release the
CONNECTOR LOCK PLATE carefully with the dental tool.
Be careful not to injure yourself or the connector
under the CONNECTOR LOCK PLATE with the sharp end
of the dental tool!