Nokia E7-00 - Page 18

Nokia E7-
00
RM-626
Service Manual Level 1&2
18 Confidential | Copyright © 2010 Nokia | All rights reserved Version 1.0
31) Open the three shown clips holding the ENGINE
BOARD FRAME ASSEMBLY with the SRT-6 as shown.
32) Remove the ENGINE BOARD FRAME ASSEMBLY.
33) Use the RF connector tool SS-231 to release the
two coax cables. First place the tool on top of the
cable.
34) Then slide it to direction shown to lock it to the
connector. Pull up the SS-231 to release the cable.
35) Use the same procedure on the second cable
connector.
36) Turn the ENGINE BOARD carefully around. Open
the UI FLEX connector with the SRT-6. Be careful not
to damage the connector or nearby components!