Select from the following:
• Proxy server address — Enter the host name or IP
address of the proxy server in use.
• Realm — Enter the proxy server realm.
• User name and Password — Enter your user name
and password for the proxy server.
• Allow loose routing — Select if loose routing is
allowed.
• Transport type — Select UDP, Auto, or TCP.
• Port — Enter the port number of the proxy server.
Edit registration servers
Select Options > New SIP profile or Edit > Registrar
server.
Select from the following:
• Registrar server address — Enter the host name
or IP address of the registrar server in use.
• Realm — Enter the registrar server realm.
• User name and Password — Enter your user name
and password for the registrar server.
• Transport type — Select UDP, Auto, or TCP.
• Port — Enter the port number of the registrar
server.
Net call settings
Select Menu > Tools > Settings > Connection >
Internet tel..
To create a new net call profile, select Options > New
profile.
To edit an existing profile, select Options > Edit.
Configuration settings
Select Menu > Tools > Settings > Connection >
Configurations.
You can receive messages from your service provider
or company information management containing
configuration settings for trusted servers. These
settings are automatically saved in Configurations.
You may receive configuration settings for access
points, multimedia, or e-mail services, and IM or
synchronisation settings from trusted servers.
To delete configurations for a trusted server, select
Options > Delete. The configuration settings for
other applications provided by this server are also
deleted.
Restrict packet data
Select Menu > Tools > Settings > Connection >
APN control.
With the access point control service, you can restrict
packet data connections from your device to certain
access points only. Your SIM card may not support the
access point control service. Contact your service
provider for more information.
To restrict the packet data connections from your
device, select Options > Activate restrictions. You
need your PIN2 code to activate and deactivate access
point control or to edit the packet data access points
on the control list.
To add access points that can be used for packet data
connections to the control list, select Options > Add
133
Settings