• Satellite re-scan: The satellite search process will be performed again.
• Satellite add: This function is useful when the General Satellite option is selected as the TV signal type.
When the Preferred Satellite option is selected, DiSEqC settings will be automatically determined and channels
from new satellite providers will be added from new selected satellites, depending on the selected satellite
provider.
• Satellite update: If you select the Scan function, the receivable satellites and the corresponding DiSEqC
settings will be determined automatically and new channels will be added.
• Satellite manual tuning: Select the satellite on which you want to perform the manual search of the satellite
transponder on and press OK. Set the exact reception parameters of the desired satellite transponder
(frequency, symbol rate and polarization). Make sure that the signal quality and signal level indicate a sucient
value and press the Back button. Press the Right directional button to start the search. The found programs
will be saved at the end of the program list.
Channel installation Mode - General Satellite
• Satellite re-scan: The satellite search process will be performed again. As an option, you can activate
another receivable satellite and add it to the automatic search. Select another satellite and press OK. Set the
exact reception parameters of the desired satellite, the DiSEqC connections and the reception parameters of
a receivable satellite transponder (the frequency, the symbol rate, and the polarization). Make sure that the
signal quality and signal level indicate a sucient value and press the Back button. Press the Right directional
button to start the scan. The found programs will be saved at the end of the program list.
• Satellite add: Press OK to set the reception parameters of the satellite you want to add. Activate the satellite
in the satellite status and set the exact reception parameters of the desired satellite. Set the DiSEqC ports
and the reception parameters of a receivable satellite transponder (the frequency, the symbol rate, and the
polarization). Make sure that the signal quality and signal level indicate a sucient value and press the Back
button. Press the Right directional button to start the scan. The found channels will be stored at the end of the
channel list.
• Satellite update: The channel scan of the selected satellites will be started and new channels will be added
to the channel list automatically.
• Satellite manual tuning: Select the satellite on which you want to perform the manual search of the satellite
transponder on and press OK. Set the exact reception parameters of the desired satellite transponder
(frequency, symbol rate and polarization). Make sure that the signal quality and signal level indicate a sucient
value and press the Back button. Press the Right directional button to start the search. The found programs
will be saved at the end of the program list.
9.2.1.5 Auto channel update
This function enables automatic channel updates. By default, it remains deactivated. If you have individually
sorted channels to maintain a specic order, it’s advisable to keep this function disabled.
9.2.1.6 Channel update message
This function enables automatic channel updates. By default, it remains deactivated. Enable this function if
you’d like to receive on-screen notications when new channels become available.
9.2.1.7 Parental controls
This menu allows you to congure parental control options. To access it, you’ll need to enter the PIN code you
set during the initial TV setup process.
9.2.1.8 Open-source licences
Here you will nd information about Open-Source licences.
9.2.2 Inputs
Here you will nd information about devices connected to the HDMI inputs of your TV and the HDMI-CEC
operation options.
29
To Next Page
Loading...