Get started
9
the green indicator light is displayed. The loopset tries to connect to the
last used device.
When the loopset is connected to your device and is ready for use, the
indicator light slowly flashes blue. If the loopset has not been paired with
a device, it automatically enters pairing mode (see “Pair and connect to
another device”, p. 9).
Switch off
To switch off, press and hold the multifunction key for over 5 seconds. The
loopset vibrates twice and plays a descending sequence of beeps, and the
red indicator light is briefly displayed.
If the loopset is not connected to a paired device within about 30
minutes, it switches off automatically.
■ Pair and connect to another device
If your phone supports the A2DP Bluetooth profile and has a music player
feature, you can use the phone to also play music through the loopset.
If your phone does not support the A2DP Bluetooth profile, you can
separately pair the loopset with the phone and a music player that
supports this profile. If you have paired and connected the loopset to your
phone, disconnect the loopset before pairing the loopset with the music
player.
1. Ensure that your phone or music player is switched on.
HS-67WL_UG_en_Draft10_with_FCC&IC_notice.fm Page 9 Tuesday, December 23, 2008 10:26 AM
To Next Page
Loading...
Need help?
General
