GB 10
Connecting an Analogue Satellite Receiver and a VCR
Nokia Smart Switch
Connecting a HiFi System
• Connect an RCA/Cinch stereo cable from the AUDIO L R sock-
ets on the Mediamaster to the LINE, AUX, SPARE or EXTRA
input sockets on your HiFi system.
• If available you can connect an RCA/Cinch single cable from
the DIGITAL AUDIO socket on the Mediamaster to your HiFi
or Dolby Pro Logic system.
Note: To avoid interference you must use a screened audio
cable.
VCR
• Connect a SCART lead between the main SCART socket on
the TV and the TV SCART socket on the Mediamaster.
• Connect a SCART lead between the VCR and the AUX SCART
socket on the Mediamaster.
• Connect an RF lead from the RF output on the VCR to the TV
aerial input on the TV.
• Connect an RF lead from the RF output on the
Analogue receiver to the RF input socket on the
VCR.
• Connect the TV aerial to the RF input socket on the Analogue
receiver.
In order to switch the signal from the dish between the ana-
logue and digital receivers, you need a Nokia Smart switch (at
A B in the diagram) or a Universal Twin LNB.
With Nokia Smart
switch
Analogue receiver
Mediamaster
SCART
RF
Nokia Smart switch
• Connect a coaxial cable between output A on the NOKIA Smart
switch (accessory) to the LNB socket on the analogue
receiver.
• Connect a coaxial cable between output B on the NOKIA Smart
switch to the ANTENNA socket on the Mediamaster.
The analogue receiver must be switched to OFF (standby) when
you want to watch digital satellite channels from the
Mediamaster.
INSTALLATION OF THE MEDIAMASTER
To Next Page
Loading...
