8
QUICK GUIDE
1) Assemble the device as per the instructions on page 2.
2) Press the Power & Settings Button once to turn on
the device.
3) When the device is turned on, it will start in the
2-tone Field mode. You can change the mode based
on ground conditions. For instance, if you are detecting
on wet beach sand, you may want to select the Beach
mode. You can find more details on search modes
further in this manual.
25
4) You can increase the sensitivity if needed. Increasing
the sensitivity will offer you greater depth. However, if
the surroundings or the ground cause excessive noise
in the device, you need to lower the sensitivity setting.
25
5) Testing the device with various metals would be
helpful for getting familiar with the sounds produced
by the device.
6) Use the Notch Discrimination setting to eliminate
unwanted metals from detection such as trash.
SIMPLEX’s Notch Discrimination consists of 50 small
boxes shown under the TARGET ID scale. Each box
represents two IDs. A single ID or multiple IDs can be
rejected or accepted based upon your preference.
7) If you are detecting in a very trashy area and the
device is getting too many iron signals, instead of Notch
Discrimination, you can use the Tone Volume setting to
lower or completely turn off the volume of ferrous
metals. This will provide more depth (this setting is
available in the ULTRA version only).
5
To Next Page
Loading...
Need help?
General
