NOMA RAY-WALL LIGHT
IMPORTANT: Please read this manual carefully before installation and save it for reference
model no. 0526141 | contact us: 1.866.827.4985
PRE-INSTALLATION:
INSTALLATION:
1) Choose an installation location where direct sunlight can be absorbed onto the face of the solar
panel for as many hours as possible throughout the day. Shadows cast by homes, trees and structures
will restrict the charging of the batteries and aect the total hours of operation of the lights.
2) During daylight hours, the sun will charge the batteries in the solar panel and the lights will turn on
at the dusk. Light output depends on how much light the solar panel receives. Position the solar panel
so that it receives maximum sunlight. If there are streetlights or other lighting that could shine directly
into or near the solar panels, these lights may trigger the light sensor and the lights may turn o.
The solar panel must sense darkness to operate
1) Assembling the solar light
NOTE: To allow each battery to reach full capacity and perform correctly, pull out the plastic tab and place the solar light in full sunlight
for the first 12 hours. Failure to do so can shorten the life of the battery or operation of the light. On cloudy or rainy days it may take
several days for the batteries to fully charge.
·Take out the wall light's package content
·Drill two holes and mount the anchors (C).
·Drill screws (B) into the anchors (C), leaving at least 5 mm of the screws (B) sticking out from the surface to hold the lamp unit.
·Mount the solar light (A) on the screws (B).
A
2) Preparing the solar panels
·Twist the white ball counterclockwise to unscrew.
·Take down the white ball.
·Turn on the switch at the back part of solar panel.
For outdoor use
Retain carton for storage purposes
Instruction Manual
B
x2 x2
C
B
C
A
To Next Page
Need help?
General
