OPERATION
Mower Clutch Lever - Used to engage or disengage the power
to the mower deck blades. With mower clutch levermoved allthe
way to DISENGAGE (rearward) position, blades should stop in
a safe period of time. Use DISENGAGE position when using as
a tractor for yard jobs such as pulling a roller, seeder, sweeper
or other accessories.
1.
Move lever slowly(Never "snap" the lever) toward frontof
lawn tractor to engage power to the blades, itis important
to engage mower clutch leverwhile engine is runningatfull
speed.
2. Move lever slowly toward rear of lawn tractor to
disengage power to blades and to apply blade brakes.
Mower clutch lever must always be In full DISENGAGE
position to start engine. Never place lever in ENGAGE
posltlonuntilengine is warmed upandoperator ison seat,
readyto startmowing.Alwaysreturn leverto DISENGAGE
position before dismounting from tractor.
(_uttine Heloht Adjustment Lever- Used to change height of
cut. The bottom position of lever is the lowest
cutting height and the top position is the highest cutting height.
Other positions change height of cut approximately 1/2 inch
each.
t.
2.
Grasp lever (RG.I-OP) with left hand and pull upward to
raise mower deck. You will hear a click sound as lever
passes to next height position.
Grasp lever with left hand and pull upward slightly. Depr'ess
button on end of lever with thumb to release height adjust-
ment lever latch and lower mower deck to
desired height. Release latch button and allow leverto latch
in place.
_k Blades will not stop immediately. Keep'_
hands and feet from under the mower deck|
and away from the discharge chute. |
J
15
To Next Page
Loading...
Need help?
General
