Nomadic NC-X3 - Remote Control Functions; Remote Control ON-OFF Function; Remote Control Power Mode; Remote Control Temperature Increase

Remote Control Description
. ON-OFF: Turns unit on and off
 Power Mode is used for fast cooling
 Eco Mode is used when resting or reading
is preferred
In Power Mode the default airflow is the biggest with the
manual adjustment
In Eco Mode compressor is running in low frequency air-
flow is defaulted as smallest with manual adjustment
Note: Strong recommendation for Power Mode less than
20 minutes Long time operation will significantly shorten
the duration of use
When cabin temperature is below ºC Auto Mode
is preferred
In different modes users can adjust the air volume
according to their needs
Please set it according to your own needs Above notes are
only for reference
Timer: After timing Temp “+” Temp “-” set the time 05
hour one level up to 10 hours press the timer key again
timer cancellation
Temp Query: Cycle switching between ambient
temperature and evaporator surface temperature
Voltage Query:Displays Voltage Reading
 Temp “+” : Temperature Increase
 Temp “-” : Temperature Decrease
 Airflow “+” : Increased Air Speed
 Airflow “-”: Decreased Air Speed
1 Auto Mode: Automatically sets thermostat to 78º
 Mode: Eco Normal Powerful
(The current product status is in the selected heating and
ventilation mode only the indoor blower works)
Error Codes and Trouble Shooting
Failure analysis of no cooling or poor effect:
() The power cord connected is too long and too thin
Poor connection at connector
() No refrigerant or insufficient refrigerant
() Eco mode is used when the temperature is
too high
() Compressor or condensing fan does not work
() The evaporator or condenser is dirty or blocked
A
S
E
 ON-OFF  Timer
 Mode
Temp “-”
 Airflow “-”
1 Auto Mode
 Temp Query
 Airflow “+”
 Temp “+”
 Power Mode
 Eco Mode
 Voltage Query