NORAUTO NS-X800 DBT - Installation Instructions; Usage Notes

134
Cleaning the connector: Wipe off dirt on the connector of the
unit and faceplate. Use a cotton swab or cloth.
Installation Instructions
● The vehicle must meet the voltage, current and power that required, please check the
conditions before installation;
● The installation should be done while the battery of the vehicle is disconnected;
● To ensure that the product has been tted with a fuse;
● The installation of the product should not a󰀨ect the safety of the operation and function of
the vehicle;
● The installation position should not block the driver's sight and should not be on the place
that the brake, steering wheel, seat belts, airbags and other vehicle safety equipment
should be;
● Please conrm the matching condition of the vehicle interface before install this product,
use the appropriate patch plug if the interface is not matched;
● Please be familiar with the connection of the vehicle before installation, conrm the position
of the piping, electrical wiring, fuel tank and other vehicle system components. Do not touch
or damage these components and avoid the exposure of wires that may cause corrosion,
leakage, etc.;
● Please do not conduct the installation in place of condensation, drench water sites, high
humidity, containing dust and oil smoke. If water, moisture, dust and oil smoke enter the
product, it may cause smoke, re or failure;
● Please do not move or disassembled the existing screws, nuts, bolts, clips, connecting
xed appliances, accessories and so on, do not change or remove vehicle incidental
contact system and wire clip, otherwise it may impair the function of automobile safety;
● In order to avoid the occurrence of re damage to the product or vehicle, please do not allow
the existing power supply circuit overload when power the product; Please be sure that the
power wires have insulation treatment and install with fuses, circuit breakers and relays;
● Please use nonconductive tape in insulation treatment, wrap the ends of the wire and
unused wire; correct insulating treatment can avoid the occurrence of electric arc, electric
shock or re. In order not to impede the brake pedal, gearbox and steering wheel, plastic
belt could be used to x the wires. Please do not make the wires contact high temperature
surface, the heat can easily cause damage to the wires and lead to short circuit, arc or re;
● Please x the wire on the electric chair or other parts of vehicle where will not lead to the
scratch or damage of wire. In addition, the wire should be xed in the hidden place as far
as possible, it will make the environment inside the vehicle beautiful;
● Please do not block the airow vents, otherwise it may cause internal overheat and re;
● After the installation is completed, please check the wire connection of the vehicle, then
run all functions, including lights, speakers, stereo, reversing operation and other electrical
systems and ensure that the vehicle function is normal and can be used safely�
Usage Notes
● Please use this product in 9 ~ 16V DC voltage range. Mismatched voltage (too high or too
low) will cause damage to the product and the battery of the vehicle;
● Please use the 15A fuse;
● Please operate the product at the temperature of -20°C to +70 °C;
● Use the soft wet cloth to wipe the stain gently;
● It is recommended to not use the product in excessive wet environment. If the function is
failed, please shut down the product and restart after the moisture dispersed;
● When restart, please use the tapered matter press the reset button lightly;
● When OS is crashed and a󰀨ects driving, please park the vehicle in the safety zone and
restart the machine;