What to do if I see a 'Lead OFF' message on Norav Medical Equipment?
If you're seeing a 'Lead OFF' message, make sure you've prepped the patient's skin according to instructions. Also, ensure the electrodes are properly applied and that the leads are making good contact with the electrodes. If the issue continues, try replacing the patient ECG cable.
Why am I getting noise artifacts on the ECG signal with my Norav Medical device?
Noise artifacts on the ECG signal can occur if the patient's skin isn't properly prepped, the electrodes aren't correctly applied, or the leads aren't making good contact. Ensure you've prepared the patient’s skin according to the instructions, the electrodes are properly applied to the patient, and the leads are making proper contact with the electrodes. Replacing the patient ECG cable can also help.
What to do if my Norav Medical Equipment displays 'Low battery' message?
If you are getting a low battery message, install a new AA battery. Also, inspect the battery compartment and clean the contacts if necessary.
What to do if my Norav Medical Equipment is connected to the dock station but the NR device drive is not visible on the computer?
If the NR device drive isn't visible, use only a Norav USB cable, and try replacing it. Also, try connecting the USB cable to another USB port. Make sure the NR-314P is correctly connected to the dock station.
How to fix 'SD Card Error' message on Norav Medical Equipment?
To resolve an SD Card Error, ensure the memory card is Norav Certified. Also, check that the memory card is not write-protected (look for a small switch on the SD Card). If problems persist, reformat the memory card or replace it with a new Norav certified memory card.
What to do if my Norav Medical Equipment displays 'No Cable' message?
If you're seeing a 'No Cable' message, first ensure the patient cable (lead set) is connected to the NR device. Then, check that the connector on the NR device side isn't damaged, and inspect the cable connector pins for any breaks, bends, or damage.
Why won't my Norav Medical Equipment power on?
To resolve the issue of the NR device not powering on, ensure the battery is inserted with the correct polarity and install a new AA battery.
What to do if my Norav Medical Equipment displays 'Previous recording found' message?
If you see a 'Previous recording found' message, download the ECG data using the Computer Analysis System, or delete it from the SD card using the left and enter buttons.
What does 'Set Date/Time (message)' mean on my Norav Medical device, and how do I fix it?
The 'Set Date/Time' message indicates that the internal battery that runs the real time clock may not be fully charged. Insert a fresh AA battery into the NR device and let the NR device charge for 12 hours.
General| Category | Medical Equipment |
|---|---|
| Manufacturer | Norav Medical |
| Series | NR Series |
| Parameters | ECG |
| Connectivity | Bluetooth, Wi-Fi, USB |
To Next Page
