Norcold N610 User Manual

1
Part No. 623934A (11-02)
Owner’s Instructions -
“Cooling Unit Sensing”
Serviceman - Please give these instructions to the vehicle owner.
Owner - Please keep these instructions with your Owner’s Manual for future reference.
These instructions describe a “cooling unit sensing” feature which may not have been in the original controls of your
refrigerator. Please use these instructions in addition to those in the “Operating the Refrigerator Controls” section your
Owner’s Manual.
Operating the Refrigerator Controls - (N61X and N81X models)
Cooling unit sensing:
The controls have the ability to sense the operation of the cooling unit. If the controls sense that the cooling unit has stopped
cooling:
- The heat sources to the cooling unit are turned off and are locked out by the controls.
- The ON light flashes about five times every three seconds.
You can reset the controls and remove the fault code one time. To reset the controls, shut off and then start the refrigerator.
- To turn off the refrigerator, push the selector switch to the OFF position.
- To turn on the refrigerator, push the selector switch to the AUTO position.
If you reset the controls and the fault occurs again before the refrigerator completes a full cooling cycle:
- The heat sources to the cooling unit are turned off and are locked out.
- The ON light flashes about five times every three seconds.
- This time you can not reset the fault. Have the refrigerator serviced by your dealer or a Norcold authorized Service Center as
soon as possible.

Norcold N610 Specifications

General

Brand	Norcold
Model	N610
Category	Refrigerator
Language	English

Summary

Operating the Refrigerator Controls

Cooling unit sensing

Explains how controls sense cooling unit operation and indicators for stopped cooling, including reset procedures.

Fault Codes

ON light is off

Indicates no DC voltage or refrigerator is OFF. Check power sources and battery charging equipment.

ON light and GAS light flash

No energy source available or burner did not ignite. Check propane supply, tank valve, and pressure.

ON light is on, GAS light flashes

Burner did not ignite or re-ignite. Check propane supply, tank valve, and pressure for gas lock-out.

ON light flashes 1 time

Temperature sensor failed. Refrigerator operates on backup system. Service required.

ON light flashes 2 times

Mode switch failed. Refrigerator operates in last known mode. Service required.

ON light flashes 3 times

AC heater failed. Refrigerator operates on propane gas only. Service required.

ON light flashes 4 times

Fault within refrigerator controls. Service required.

ON light flashes 5 times

Cooling unit stopped cooling. Check vents, doors, and level. Reset once, then service.