3. Storage, Transport,
Preparation, Installation
-10- B1050-GB-0213 www.nord.com
Gear units with motor adapter
Gear units with a motor adapter may only be transported with lifting ropes (2) and chains or
lifting straps (1) at an angle of 90° to 70° to the horizontal. The ring bolts on the motor must not
be used for transportation.
Figure 3-2: Transport of gear unit with motor
Drive units with V-belt drive
Gear units with V-belt drive must only be transported with lifting straps (1) and lifting ropes (2) at
an angle of 90° (vertical). The ring bolts on the motor must not be used for transportation.
Figure 3-3: Transport of gear unit with V-belt drive
To Next Page
Loading...