Need help?Do you have a question about the Nordic Semiconductor nRF9160 DK and is the answer not in the manual?
General| Brand | Nordic Semiconductor |
|---|---|
| Model | nRF9160 DK |
| Category | Microcontrollers |
| Language | English |
Default mode for programming and debugging the nRF9160 DK via USB.
Details the three virtual COM ports for UART communication with the interface MCU.
Mode for isolating the nRF9160 SiP for current measurements.
Details the flexible power supply system, nRF9160 supply, and VDD rail regulation.
Introduces the nRF52840 SoC on the DK for control and network processing.
Details how the nRF52840 SoC controls analog switches for nRF9160 GPIO routing.
Describes the primary debug interface via USB and alternative debug connectors.
Provides an overview of solder bridges for enabling/disabling DK functionality.
Steps to prepare the DK for current measurement, including jumper removal.
Instructions on using an oscilloscope to measure current over time.
Guide on using a current meter to measure the nRF9160 DK's current draw.
To Next Page
